Taking Control of your Home Comfort

Just like your cars, your heating and cooling systems should be serviced regularly to ensure its safe and efficient operation. Our annual preventive maintenance service will ensure that your unit continues to run efficiently, saving you costs and energy by reducing gas and electrical usage.

This service includes a thorough cleaning of your furnace or air conditioner as part of our 20 point safety inspection by a certified gasfitter. Our technicians will often be able to pin point any potential problems and correct them, preventing costly and unwanted break down.

Our seasonal maintenance contract provides complete peace of mind, as what can be more frustrating than trying to find a heating contractor that will be able to fix your furnace on a cold winter's night?

Our Air Conditioning Maintenance Includes:

  • Indoor Unit
  • Check blower motor inside the furnace
  • Check the air filter
  • Check the condensate drain for restrictions
  • Check temperature difference between supply and return air
  • Check the thermostat and adjust if necessary
  • Outdoor Unit
  • Check the condenser fan motor
  • Inspect the contactor
  • Check both suction and discharge pressure
  • Check the condenser coil for visual leaks
  • Check and lubricate all necessary components
  • Check fuse and disconnect box
  • Check voltage and amperage draw on components
  • Remove all debris inside the unit
  • Check insulation on the tubing
  • Wash the condenser coil if needed
  • Check the compressor for proper and efficient capabilities
  • Check to make sure the unit is level
Our Furnace Maintenance includes:
  • Clean the furnace thoroughly with vacuum cleaner
  • Check heat exchanger for possible cracks
  • Change or clean filter
  • Lubricate blower and motor bearings
  • Check fan belt and adjust for tension
  • Check pulley and drive alignment
  • Check all wiring for damaged insulation or loose connections
  • Check electronic ignition control
  • Check vent pipes and draft hood
  • Check fan control
  • Check limit control
  • Check gas manifold pressure
  • Check for gas leaks inside of furnace
  • Clean and adjust pilot assembly
  • Adjust burners for efficiency
  • Check all safety controls
  • Check and clean thermostat
  • Operate and check furnace through complete cycle
  • Check air temperature rise
  • Check for carbon monoxide presence in house
Also available:

Fireplace Inspection, Humidifier Inspection, and Thermostat setup and programming.

Copyright © Corner Gas Heating and Cooling Inc.